Unimark XP Bedienungsanleitung PDF herunterladen (Seite 4)

Worldspan Services Ltd, Confidential

Prepared by Michael Merhej

May 26

2005

Preventive Maintenance Unimark Sprite

This section describes the preventive maintenance procedures for the SPRITE.

Although the SPRITE will perform dependably right out of the box, the operator must

do a periodic inspection and cleaning to keep it in good working order. With proper

care, the SPRITE enclosure, print head, magnetic encoder (when so equipped),

transport assembly, and other components can be expected to continue to provide

good service for many years. The following inspection and cleaning procedures are

presented separately for clarity, but may be performed at the same time.

Periodic Inspection and Cleaning

Like any piece of office equipment, the SPRITE ATB printer will need periodic

maintenance. Every three months or 12,000 coupons, the printer should

be cleaned and visually inspected. This process should take no more than ten

minutes.

Examine the enclosure's external and internal surfaces, ventilation slots,

transport assembly, and internal components for dust buildup. All dust should be

removed at least every three months to maintain performance.

 Vacuum dust accumulation from the ventilation slots and other external

surfaces of the SPRITE.

 Dampen a soft cloth or paper towel with a mild solution of soap and water or

a mild commercial cleaner and wipe the surface.

 Dry the cleaned area with a clean, dry cloth or paper towel.

 Dust is primarily produced by ticket stock passing through the transport

assembly inside the SPRITE enclosure. Clean the internal surfaces of the

enclosure as follows:

 Toggle the POWER switch to 0 (OFF).

 Unplug power cord from back of the enclosure

 Unlock door on left side of enclosure and open to a maximum of 90º.

 Remove all card stock from enclosure by rotating knurled knobs along

transport path as required.

 Vacuum as much dust as possible from inside enclosure.

 Use compressed air to blow dust from ticket stock path grooves in transport

assembly.

1 2 3 4 5 6 7 8 9

Keine Kommentare

Unimark XP Bedienungsanleitung Seite 4